Embossed Wedding Invitations

Planning a wedding is one of the highlights of life of most women. They thought for years and have considered all the ways to make it unforgettable. Now, with the engagement ring sparkling on her finger, the bride to be takes his ideas and starts to put them into practice. One of the first things she needs to review the wedding invitations. They can be handcrafted to make them truly memorable, and embossing - Machine card can make them even more special. 1. Cover your work surface for easy cleanup later. If you choose to use an additional sheet (corresponding to the color of marriage and cardboard), you can produce the appearance layers as shown above. Choose a stamp that you want to use your card. A number of different timbres can be combined to give a more personal touch to your card. The raised ink itself is clear, as are markers embossing and a pen. Embossing powders are available in a wide variety of colors. Choose colors that will showcase your creations and give you the look you want. 2. Practice with your stamp and powders using scrap paper. For better buffer, put the seal on the keypad and tap lightly on top. The idea is to ink the pad without it as the model does not pass through. Press down on the stamp without rubbing or rolling it back and forth to produce a sharp image. Once you put the ink on the paper, immediately cover it with embossing powder. Press to remove excess, using a small brush if necessary. Remove the powder did not adhere to the inked image. 3. Heat the ink / image powder using a heat gun. Hold the gun several inches of your paper and move slowly back and forth. The image will begin to increase. Once the image has grown and hardened, you can turn off the heat. Allow the design to cool before continuing. Continue to practice technique and design until you have the image you want. 4. Start designing your invitation. Print the information you want your invitation on card stock before cutting to size. This information should include the date, time and place of marriage and the location of the reception. If you make a layered effect, cut the colored paper to size and glue on cardboard before embossing - embossing card machine 5. Relief your design using the above techniques. Once the design is cool, you can check areas that have not been raised properly. Arriving at these domains using a marker or pen embossing. You can also use a special pen or marker to create loops or ornaments. 6. Add a ribbon or decorative touches to improve still further the card - card dump , then get ready to post.